20-11-2013, 11:49 AM
(20-11-2013, 10:54 AM)silverzx Wrote: How have you plumbed your EMP probe/gauge in? Ruan's told me they aren't the easiest thing to keep secured.
Tis a thing of beauty and a complete lashup (naturally), people think I have a brake line running over my engine. Unfortunately it doesn't look like I have any photos. Will see if I can get some tonight.
Drilled and tapped the manifold, screwed a fitting in, flared a length of copper brake line and clamped that to the fitting. Ran that up to the top of the inlet manifold, slid another brake fitting on, flared the end of the copper, screwed into a brass fitting that changes the pipe to the small nylon type. Run that inside the car up to the dash and connected it to a random gauge I found.
as said, a bit of a bodge, but its secure enough, was nigh on FOC to do (which is always good), and works fine.