Well guys, its fmic time soon and ive tapped my inlet with a nice nipple for the boost gauge, so the gauge will be run from there.
Any tips on fitting the boost controller to the hdi? I took to it today to get an idea of the fmic install and mbc install, and I can only access one side of the waste gate pipe. The side that goes to the actuator is nowhere to be seen, so what way did you guys fiy yours, any tips on how to access the other side, or should I just get a joiner and use the existing pipe? Ideally I want to replace it all if possible.
Does the engine need to come off certain mounts to get access?
Any tips on fitting the boost controller to the hdi? I took to it today to get an idea of the fmic install and mbc install, and I can only access one side of the waste gate pipe. The side that goes to the actuator is nowhere to be seen, so what way did you guys fiy yours, any tips on how to access the other side, or should I just get a joiner and use the existing pipe? Ideally I want to replace it all if possible.
Does the engine need to come off certain mounts to get access?