Wheel Refurbishment

[Kezzieboy]

I may have found myself a set of ninja wheels that I can make fit, and that I've never seen on a 306 before, however they are in awful condition. They're all straight, but down to bare metal around the whole lip on 3 of the 4 wheels and fairly corroded.

Normally, I'd break out the sandpaper etc. and get on with it, but the design would be a massive pain, and so I'm looking at alternatives. So...

1. How much does it cost to sandblast a set of wheels, usually?

2. Is it easy to refurbish a set of wheels from bare metal? For either me, or a pro.

3. What about powdercoating? Expensive? Could I paint over powdercoat if they don't have the exact colour I want?

That's about it really, cheers chaps!