Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ph2 IR central locking conversion to RF
#1
some may know how poor the rang is on the Ph2 key fob, as i have a ph3 i get pissy with the ir system as i cant unlock the car on approach
small thing and that

with this guide i hope to be able to show you how to convert the central locking to RF for better range.

Beware this is a work in progress and some pictures wont work yet

objective.
nice flip key fob
working Immobiliser
remote locking
working dead locks

Extras maybe
Boot popper or other auxillary output

i have bought a Keyless entry remote system off of ebay

http://www.ebay.co.uk/itm/360621012598

   

the good thing with this kit is you can request the key blank and branding for the peugeot key and fob branding sticker

   

the kit came i read the instruction well i didn't at first! but i had to in the end Blush

ive never worked on a central locking system before but i have good electrical knowlage so my first job was to uncover all the box's in the car i am going to be connecting too

first box is the Central locking control box, in my Ph2 is is under the shelf drivers side under the rear bench seat

   

second box is the alarm box this box is located drivers side rear quater panel just above the front seatbelt recoil unit

   

If you unscrew each of the box's you can gain enough wire to work on each easyer

   

now i had all the box's exposed it was time to find out how the c/locking worked and what wires did what

this is where i had to go back and read the kits manual twice
as although ebay seller said instructions included that was a load of rubbish as there was nothing in the manual for peugeot at all!

on reading the manual again i learned
while this is installing a new remote centrol locking control box, this box only triggers the original equipment box to lock and unlock the original system
so the IR system with the original key will still work if you want

so effectivly this unit could be used on any car say if you lost the R/CL fob but still had the keyand immo chip.

The manual did explain how to check/test for which type of central locking system the car has

   

so after following the instructions
i came to the conclusion the 306 PH2 use's a negative trigger system
Reply
Thanks given by:


Messages In This Thread
Ph2 IR central locking conversion to RF - by cully - 22-08-2013, 02:23 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)