13-02-2012, 10:45 PM
find all the needle rollers, clean out all the crap grease in cv boot.
using new,fresh grease--literally stick the rollers to the shaft
refit the roller bearing over needles to keep them in place
slap fresh grease over other 2 rollers on the tripod to keep it all in place
refit shaft into joint, bang on a new metal clip or cable tie if need be to secure the inner cv boot.
using new,fresh grease--literally stick the rollers to the shaft
refit the roller bearing over needles to keep them in place
slap fresh grease over other 2 rollers on the tripod to keep it all in place
refit shaft into joint, bang on a new metal clip or cable tie if need be to secure the inner cv boot.