Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hub identification?
#7
(15-08-2013, 12:40 PM)Piggy Wrote:
(15-08-2013, 12:27 PM)Mattcheese31 Wrote: generally phase 1 tends to be 16mm, phase 2 either or and phase3 18mm Smile

so wrong!

My phase 1 is 18mm and the phase 3 I have is 16mm!


According to motor factor books it used to be based on PAS or non PAS...but that hasnt fitted in my experience either

its french there will be no logic to this just measure it or as matt said buy 2 sets and take 1 back
Reply
Thanks given by:


Messages In This Thread
Hub identification? - by RhysBoost - 15-08-2013, 12:22 PM
RE: Hub identification? - by adamm306 - 15-08-2013, 12:23 PM
RE: Hub identification? - by Mattcheese31 - 15-08-2013, 12:27 PM
RE: Hub identification? - by Piggy - 15-08-2013, 12:40 PM
RE: Hub identification? - by titch - 15-08-2013, 12:43 PM
RE: Hub identification? - by Mattcheese31 - 15-08-2013, 12:49 PM
RE: Hub identification? - by RhysBoost - 15-08-2013, 12:30 PM
RE: Hub identification? - by Mattcheese31 - 15-08-2013, 12:35 PM
RE: Hub identification? - by adamm306 - 15-08-2013, 12:42 PM
RE: Hub identification? - by Piggy - 15-08-2013, 02:02 PM
RE: Hub identification? - by Mattcheese31 - 15-08-2013, 02:45 PM
RE: Hub identification? - by jammapic - 15-08-2013, 02:08 PM
RE: Hub identification? - by Piggy - 15-08-2013, 02:09 PM
RE: Hub identification? - by Niall - 15-08-2013, 03:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)