04-08-2013, 05:39 PM
(04-08-2013, 08:23 AM)C2K Wrote: Got pics of your replaced pipework? How much hassle was it to remove them?
I you need to jack it up get, remove the undertray, front bumper, headlights and unbolt the slam panel. I disconnected the pipes from the compressor and the receiver drier and the upper springlock coupler.
With the slam panel pulled back there is a big enough gap to lift the condenser out with two attached pipes.
Refitting a new condenser and pipes will take a lot longer due to adjusting pipes to fit properly. Also you may find the condenser housing may need modding to get it to fit and also the lower pipe connection which I had to bend further than I liked.