306oc - Peugeot 306 Owners Club & Forum › General › The Couch v
Might *HAVE* gone a tad low.....

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Might *HAVE* gone a tad low.....
Dum-Dum Offline
Lord of Unfinished Projects
Posts: 15,646
Threads: 541
Joined: Dec 2011
Reputation: 124
Location: Aylesbury
Car Model/Spec: 320bhp Impreza WRX
Thanks: 7
Given 59 thank(s) in 58 post(s)
#21
26-07-2013, 07:46 AM
(25-07-2013, 11:13 PM)ConorTRG Wrote: Are they 13's? go much lower and it'll break your heart, ive 13" steelies on the front of mine at the minute and it would catch a right bit unless you watch where your going, mines a bit lower though.
Nah, they are 16s mate.
Find
Reply
Thanks given by:


Messages In This Thread
Might *HAVE* gone a tad low..... - by Dum-Dum - 25-07-2013, 02:10 PM
RE: Might of gone a tad low..... - by Matt - 25-07-2013, 02:15 PM
RE: Might of gone a tad low..... - by 1616six - 25-07-2013, 02:15 PM
RE: Might *HAVE* gone a tad low..... - by Ed Doe - 25-07-2013, 02:22 PM
RE: Might *HAVE* gone a tad low..... - by sam - 25-07-2013, 02:25 PM
RE: Might *HAVE* gone a tad low..... - by Dum-Dum - 25-07-2013, 02:37 PM
RE: Might *HAVE* gone a tad low..... - by sam - 25-07-2013, 02:40 PM
RE: Might *HAVE* gone a tad low..... - by Matt - 25-07-2013, 02:42 PM
RE: Might *HAVE* gone a tad low..... - by Dum-Dum - 25-07-2013, 02:55 PM
RE: Might *HAVE* gone a tad low..... - by Matt - 25-07-2013, 03:17 PM
RE: Might *HAVE* gone a tad low..... - by Grant - 25-07-2013, 03:29 PM
RE: Might *HAVE* gone a tad low..... - by puglove - 25-07-2013, 03:37 PM
RE: Might *HAVE* gone a tad low..... - by Dum-Dum - 25-07-2013, 03:48 PM
RE: Might *HAVE* gone a tad low..... - by puglove - 25-07-2013, 06:31 PM
RE: Might *HAVE* gone a tad low..... - by kingy - 25-07-2013, 06:05 PM
RE: Might *HAVE* gone a tad low..... - by Piggy - 25-07-2013, 06:25 PM
RE: Might *HAVE* gone a tad low..... - by Dum-Dum - 26-07-2013, 07:46 AM
RE: Might *HAVE* gone a tad low..... - by Pete - 26-07-2013, 10:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)