So pissed off - Cobra Subframes

[Rich306]

To whom it may concern

Two months after ordering my sub frames they finally arrived! The bolts line up fine to the seats, however only 3 of the 4 bolts line up correctly with the car. The 4th bolt is around 40mm out. The door side of the car has around 250mm between the bolts (fits fine) and the distance between the inside bolts is around 290mm. The subframes are about 250mm on both sides so there is no way I can make them fit.

I ordered these 'Direct fit' sub frames a long time ago to ensure I would have them ready for car shows and Track time, however this has been a major inconvenience as i have been unable to enjoy the full benefit of Bucket seats due to being unable to fit them!!
My original intention was to not mess around welding and making the existing subframes fit, hence spending £100 on this particular set.

Since this has been a complete failure, i would like a full explanation as to why this has happened and also request that something be done regarding these subframes. A refund of some form would also be appreciated

Regards,
Sam Rowell