16-07-2013, 03:27 PM
Hi I'm having many problems with my second engine. All set up in a boat and went to start but it stopped suddenly so checked the head and the cam shaft was broke so got another head and set up with new belt and set the torque put all back together then went to turn over but all I get it the spinning sound of the motor bought another starter motor and that does the same so I turned the engine a bit by hand and tried again and first of all it moved a bit but was very rough then it started just to spin again again I could fill the teeth on the drive plate but they seem fine could I have broke something else like I said the engine turns fine by hand. Going to look for another xud engine if some one comes up with one then will pull this one part and recondition it over time
Ps didn't put any full stops as I read that this is not used
Thanks to all
Ps didn't put any full stops as I read that this is not used
Thanks to all