12-07-2013, 12:29 AM
(12-07-2013, 12:15 AM)Poodle Wrote: Yes they would be, you'd need a lot of stretch to keep it legal. :S
Just need the last bit of my post - sorry, forget the stuff about spigots, getting the centres bored will do the same job and do it better. Your local engineering shop should be able to sort you out.
5 or 10mm spacers on the rear should set it where you want it. Standard 306 offset is 15-18, so at et16 these will fit as standard. BUT, they're an inch wider than standard wheels (half an inch each side of the centre line) so will stick out 12-13mm further anyway. That means the fronts are where you want them and the rears will only need 5mm-10mm, make sense?
Can i suggest you do a bit of reading around, just so you understand what you're working with. I'd hate to give advice that was misinterpreted and you end up out of pocket/time as a result.
I'll ring a few local engineering firms in the morning and see what they can do for me, may not even bother with the spacers till a later date if they're not actually needed for fitment I just thought I'd get two birds with one stone if I actually needed some to fit them :p
I've worked out they need to bore 1.9mm away for them to be the 65.1mm for pug fitment, could they actually do it that specifically or would it have to be 2mm?
I'll make sure to do some further research so I know exactly what I'm doing. Thanks a lot though, repped
