Yes they would be, you'd need a lot of stretch to keep it legal. :S
Just need the last bit of my post - sorry, forget the stuff about spigots, getting the centres bored will do the same job and do it better. Your local engineering shop should be able to sort you out.
5 or 10mm spacers on the rear should set it where you want it. Standard 306 offset is 15-18, so at et16 these will fit as standard. BUT, they're an inch wider than standard wheels (half an inch each side of the centre line) so will stick out 12-13mm further anyway. That means the fronts are where you want them and the rears will only need 5mm-10mm, make sense?
Can i suggest you do a bit of reading around, just so you understand what you're working with. I'd hate to give advice that was misinterpreted and you end up out of pocket/time as a result.
Just need the last bit of my post - sorry, forget the stuff about spigots, getting the centres bored will do the same job and do it better. Your local engineering shop should be able to sort you out.
5 or 10mm spacers on the rear should set it where you want it. Standard 306 offset is 15-18, so at et16 these will fit as standard. BUT, they're an inch wider than standard wheels (half an inch each side of the centre line) so will stick out 12-13mm further anyway. That means the fronts are where you want them and the rears will only need 5mm-10mm, make sense?
Can i suggest you do a bit of reading around, just so you understand what you're working with. I'd hate to give advice that was misinterpreted and you end up out of pocket/time as a result.