Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Nimrods onto 306?
#8
(09-07-2013, 03:51 PM)Dum-Dum Wrote: The wheels are the same center bore yes

Its 13mm spacers you want all round to make it the same offset as the 306 as the wheels are ET31 and the 306 uses ET18. 31-18=13mm

Is that £85 posted with bolts cos if so thats VERY good. I was paying £37 a pair for spacers alone.

Make sure you get the right sort of bolts as pug wheels take flat seat bolts not the taper seat bolts that you often get given. If you use the taper seat bolts youll f*ck your wheels and they will work loose over time as the bolt damages the wheel.

Going to go for a bit wider stance I think so may even go 15 front and 20 on the rear to fill the arches out a bit more, or would this cause rubbing on the arches on full lock? Not dropping it stupidly low, just so the arches sit well over the wheels, I want the car to handle reasonably well and also be practical for every day use.

IIRC the 15mm ones I saw are made by JJC but they come with tapered bolts so I'll have to get some others. They are £38.30 off eBay, and the 20mm ones are also by JJC and cost £44.71 so roughly it's £82 and free delivery Big Grin

Would 2 sets of these do the trick? 55mm long so seems like plenty of thread

clicky

Cheers
Reply
Thanks given by:


Messages In This Thread
Nimrods onto 306? - by rtha6551 - 08-07-2013, 10:21 PM
RE: Nimrods onto 306? - by Stephen - 08-07-2013, 10:23 PM
RE: Nimrods onto 306? - by rtha6551 - 08-07-2013, 11:22 PM
Nimrods onto 306? - by Stephen - 08-07-2013, 11:28 PM
RE: Nimrods onto 306? - by puglove - 09-07-2013, 05:46 AM
RE: Nimrods onto 306? - by rtha6551 - 09-07-2013, 03:39 PM
RE: Nimrods onto 306? - by Dum-Dum - 09-07-2013, 03:51 PM
RE: Nimrods onto 306? - by rtha6551 - 09-07-2013, 04:59 PM
RE: Nimrods onto 306? - by Dum-Dum - 09-07-2013, 05:17 PM
RE: Nimrods onto 306? - by rtha6551 - 09-07-2013, 06:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)