19-05-2013, 05:23 PM
Need to wind the piston back in. Its on a thread. I used a bit of metal in the cut outs in the piston to wind it back in but you could also tap it round with a screw driver. Wind it back in and your pads should fit.
Oh and once you wind it right back in, you might find that the first time you press the pedal, it may go lower than normal (start the car and just pump it a few times before driving it) and you may also get a little weep of fluid from around the piston after winding in.
Oh and once you wind it right back in, you might find that the first time you press the pedal, it may go lower than normal (start the car and just pump it a few times before driving it) and you may also get a little weep of fluid from around the piston after winding in.
Team Eaton
1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft