12-05-2013, 05:11 PM
If your doing it the Nick "notch" method just take shocks off at the bottom bolt, anti roll bar out nut off the end of torsion bar then smack the trailing arm off adjust to were you want (1 of the 4 notches) then push it in do same other side put it back together doesn't matter about the off set washer if doing it that way.
But becareful when knocking trailing arms off if your bearings are naffed then they will fall to bits when you take the arm off.
But becareful when knocking trailing arms off if your bearings are naffed then they will fall to bits when you take the arm off.