306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Are these rods scrap?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Are these rods scrap?
Dum-Dum Offline
Lord of Unfinished Projects
Posts: 15,646
Threads: 541
Joined: Dec 2011
Reputation: 124
Location: Aylesbury
Car Model/Spec: 320bhp Impreza WRX
Thanks: 7
Given 59 thank(s) in 58 post(s)
#9
08-05-2013, 03:43 PM
You could get it welded to fill it then re bore the rod as it's only the surface the bearing sits on not the actual bearing surface but that will cost as much as a hdi lump.

If the set is going free take it and keep the good ones and then you only have to find two more.
Find
Reply
Thanks given by:


Messages In This Thread
Are these rods scrap? - by martyn92 - 08-05-2013, 10:40 AM
RE: Are these rods scrap? - by cully - 08-05-2013, 10:43 AM
RE: Are these rods scrap? - by declantg - 08-05-2013, 11:07 AM
RE: Are these rods scrap? - by Midnightclub - 08-05-2013, 11:08 AM
RE: Are these rods scrap? - by puglove - 08-05-2013, 11:31 AM
RE: Are these rods scrap? - by Tom - 08-05-2013, 11:48 AM
RE: Are these rods scrap? - by martyn92 - 08-05-2013, 02:58 PM
RE: Are these rods scrap? - by darrenjlobb - 08-05-2013, 03:08 PM
RE: Are these rods scrap? - by Dum-Dum - 08-05-2013, 03:43 PM
RE: Are these rods scrap? - by Dave - 08-05-2013, 04:31 PM
RE: Are these rods scrap? - by Toms306 - 08-05-2013, 04:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)