10-04-2013, 07:47 PM
Ive done it/ am in the process of doing a swap with the later model engine which needed stand alone ecu but you will need.
-engine and box
- a means to convert the clutch mechanism from pull to push type (this was the biggest faff)
- custom top engine mount
- you can reuse a mix of the dturbo/ V6 gearbox mount.
- custom drive shafts
- new rad, i got one from a golf vr6 mk3 as the outlets are on the same side and make things easier.
- an angle grinder, a big hammer and some cable ties.
can't think of anything else off the top of my head but my build thread is on Club-306
-engine and box
- a means to convert the clutch mechanism from pull to push type (this was the biggest faff)
- custom top engine mount
- you can reuse a mix of the dturbo/ V6 gearbox mount.
- custom drive shafts
- new rad, i got one from a golf vr6 mk3 as the outlets are on the same side and make things easier.
- an angle grinder, a big hammer and some cable ties.
can't think of anything else off the top of my head but my build thread is on Club-306