21-03-2013, 12:20 PM
Help please peeps
Just bought a 2001 306 HDI for work and love it, everything was working great, steering wheel was well worn so I changed for another with leather on, i did not disconnect the battery for this.
I also fixed a ton of bulbs to the dash cluster and centre console, orange wire had pulled from the radio connector block so connected that up also (dont think that will cause any problems)
Until now airbag, side airbag and seatbelt lights would light up and they would go out after a few seconds or when the seat belts were attached.
Since fitting the tidier steering wheel,
No seat belt warning light
No side airbag warning light
Airbag light stays lit constant
I have soldered the earth wires under the seat
I have checked the red and orange connectors and no matter how much they are disturbed they do not lose connection
All I can think of is either:
The airbag module is now faulty
or
Steering wheel airbag is not making a contact
Can I buy another airbag module and just plug it in or does it require linking up to the car via peugeot?
I would like toi check to see if I have a good connection from the rear plug on the squib to the airbag, can I connect the airbag and then use a continuity tester to see if there is a circuit?
I have just also found out that this is now a mot test faiulure, bugger!
Your help would be appreciated I have already spent hrs trying to resolve!
I do have a friend at a garage who has a snap on gadget for reading codes and removing them, he is unable to remove a code hence I am thinking an open circuit messing up seat belt, side airbag and airbag warning light!
Just bought a 2001 306 HDI for work and love it, everything was working great, steering wheel was well worn so I changed for another with leather on, i did not disconnect the battery for this.
I also fixed a ton of bulbs to the dash cluster and centre console, orange wire had pulled from the radio connector block so connected that up also (dont think that will cause any problems)
Until now airbag, side airbag and seatbelt lights would light up and they would go out after a few seconds or when the seat belts were attached.
Since fitting the tidier steering wheel,
No seat belt warning light
No side airbag warning light
Airbag light stays lit constant
I have soldered the earth wires under the seat
I have checked the red and orange connectors and no matter how much they are disturbed they do not lose connection
All I can think of is either:
The airbag module is now faulty
or
Steering wheel airbag is not making a contact
Can I buy another airbag module and just plug it in or does it require linking up to the car via peugeot?
I would like toi check to see if I have a good connection from the rear plug on the squib to the airbag, can I connect the airbag and then use a continuity tester to see if there is a circuit?
I have just also found out that this is now a mot test faiulure, bugger!
Your help would be appreciated I have already spent hrs trying to resolve!
I do have a friend at a garage who has a snap on gadget for reading codes and removing them, he is unable to remove a code hence I am thinking an open circuit messing up seat belt, side airbag and airbag warning light!