306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Making a custom exhaust

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Making a custom exhaust
silverzx Offline
Always leaves skidz

Registered users - Donated
Posts: 4,926
Threads: 266
Joined: Dec 2011
Reputation: 18
Location: Somerset
Car Model/Spec: 205 DTurbo
Thanks: 73
Given 7 thank(s) in 7 post(s)
#1
13-03-2013, 06:44 PM
Anyone have any views, opinions or advice on this?

In theory you could make a full turbo back system just using straight pipes and flexible joiners with whatever bore you wanted.

Also leaks wouldn't be a major issue as its a XUD.

You can get 3 meters of 3" stainless steel for £65 on ebay, flexible joiners are about £20.

Can you see where this is going? Blush
Supercharged GTi6 Build
S14 Zenki Build
[Image: signature.png]
Find
Reply
Thanks given by:


Messages In This Thread
Making a custom exhaust - by silverzx - 13-03-2013, 06:44 PM
RE: Making a custom exhaust - by Ben - 13-03-2013, 06:52 PM
RE: Making a custom exhaust - by ozonehostile - 13-03-2013, 07:04 PM
RE: Making a custom exhaust - by strictly_perv - 13-03-2013, 07:07 PM
RE: Making a custom exhaust - by Tom - 13-03-2013, 07:13 PM
RE: Making a custom exhaust - by Dicky - 13-03-2013, 07:20 PM
RE: Making a custom exhaust - by silverzx - 13-03-2013, 08:27 PM
RE: Making a custom exhaust - by Daniel306 - 13-03-2013, 09:43 PM
RE: Making a custom exhaust - by Ben - 14-03-2013, 05:13 PM
RE: Making a custom exhaust - by Just Sean - 13-03-2013, 09:49 PM
RE: Making a custom exhaust - by Jonny81191 - 13-03-2013, 10:33 PM
RE: Making a custom exhaust - by RJDubya - 14-03-2013, 12:03 AM
RE: Making a custom exhaust - by Daniel306 - 14-03-2013, 05:32 PM
RE: Making a custom exhaust - by Ben - 14-03-2013, 06:02 PM
RE: Making a custom exhaust - by anto - 16-03-2013, 06:59 PM
RE: Making a custom exhaust - by Dave - 17-03-2013, 02:16 PM
RE: Making a custom exhaust - by londondan86 - 17-03-2013, 10:22 PM
RE: Making a custom exhaust - by RJDubya - 17-03-2013, 11:13 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)