|
changing a cam shaft in xud
|
Posts: 4,604
Threads: 90 Joined: Dec 2011 Reputation: 54 Location: Cornwall Car Model/Spec: 1996 306 DT M-TDI/16 
Thanks: 0
Given 20 thank(s) in 18 post(s)
27-02-2013, 08:35 PM
No problems at all Joe changing the cam...changing the caps is where the problem is or over tighening the bolts...just makes bearings pick up / cam break....the XUD 9 cam will fit your xud7 but cant reember if the pump bolts on / oil feed is there?
Tbh id just drop an XU9 in it.... | Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia | ![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
changing a cam shaft in xud - by kernow_joe - 26-02-2013, 10:51 PM
changing a cam shaft in xud - by Jake - 26-02-2013, 11:07 PM
RE: changing a cam shaft in xud - by kernow_joe - 26-02-2013, 11:16 PM
Re: changing a cam shaft in xud - by kernow_joe - 27-02-2013, 03:13 PM
RE: changing a cam shaft in xud - by Dave - 27-02-2013, 08:28 PM
RE: changing a cam shaft in xud - by darrenjlobb - 27-02-2013, 08:35 PM
RE: changing a cam shaft in xud - by kernow_joe - 27-02-2013, 08:38 PM
RE: changing a cam shaft in xud - by darrenjlobb - 28-02-2013, 08:34 AM
RE: changing a cam shaft in xud - by kernow_joe - 28-02-2013, 12:11 PM
RE: changing a cam shaft in xud - by darrenjlobb - 28-02-2013, 12:44 PM
RE: changing a cam shaft in xud - by kernow_joe - 28-02-2013, 12:57 PM
|
