16-02-2013, 08:50 PM
(This post was last modified: 16-02-2013, 08:56 PM by dturbopeck.)
![[Image: ny4ytuje.jpg]](http://img.tapatalk.com/d/13/02/17/ny4ytuje.jpg)
well got around to removing the pump again today, and it looks like it was my fault too, must of over tightened the throttle arm and its eaten through the washer on the bottom and eat halfway through gov cradle, and all the little bits of metal gone into the pump and damaged the cam plate and blocked the filter in the 12mm head, i will add a pic later,
so ive cleaned it all up, rebuilt it back up with all the levers, gov cradle and the top housing of the pump also left the standard lda pin in as its alot more agressive from the 12mm pump, now it seems to run fine but i havent drove it yet as i may as well do the brake master cylinder while the engine mount is off tomorrow.