13-02-2013, 12:54 PM
Does the motor smeel / seem hot? If its near the red, when you lift the bonnet it will be "hot / oiley" kinda thing, u can normally tell wen a motor is actually overheating...
No pressure in the tank i assume after a drive? given it was fine before the loom swap? and you didnt change any of the sensors? it would seem like some kind of electrical issue is kicking off to me... trace the wires from the sensor that runs the dash gauge and make sure there not bare anywhere / bad connection on engine connector etc...dosnt take much to throw it right off with gauges.
No pressure in the tank i assume after a drive? given it was fine before the loom swap? and you didnt change any of the sensors? it would seem like some kind of electrical issue is kicking off to me... trace the wires from the sensor that runs the dash gauge and make sure there not bare anywhere / bad connection on engine connector etc...dosnt take much to throw it right off with gauges.
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
| #DervMafia |