306oc - Peugeot 306 Owners Club & Forum › 306 Repairs & Mods › Guides v
[How to] Manufacturing an upper BAR 306

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[How to] Manufacturing an upper BAR 306
Slam Wagon Offline
Living for the 306

Registered users - Donated
Posts: 1,756
Threads: 79
Joined: Jun 2012
Reputation: 17
Location: Stroud, Gloucestershire
Car Model/Spec: Down and out HDi racestate
Thanks: 0
Given 0 thank(s) in 0 post(s)
#15
07-02-2013, 02:25 PM
(03-02-2013, 06:25 PM)Jenkosowls Wrote: [Image: DSCN0970.jpg]

Could you not add a bar straight across above the inlet, i know it wouldnt be as good as straight between the struts but would stop the bent taking all the sideways pressure.
[Image: sig002_zpscb892e18.jpg]
Website Find
Reply
Thanks given by:


Messages In This Thread
RE: Manufacturing an upper BAR 306 - by fan2xud - 03-02-2013, 05:39 PM
RE: Manufacturing an upper BAR 306 - by fan2xud - 03-02-2013, 09:19 PM
RE: Manufacturing an upper BAR 306 - by Eeyore - 03-02-2013, 09:40 PM
RE: Manufacturing an upper BAR 306 - by Curt - 03-02-2013, 09:52 PM
RE: Manufacturing an upper BAR 306 - by fan2xud - 03-02-2013, 10:12 PM
RE: Manufacturing an upper BAR 306 - by fan2xud - 04-02-2013, 11:03 PM
RE: [How to] Manufacturing an upper BAR 306 - by Slam Wagon - 07-02-2013, 02:25 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  GUIDE: Fitting Upper & Lower Strut Braces Eeyore 39 34,843 29-03-2015, 01:42 PM
Last Post: Rippthrough
  Manufacturing an upper strut brace fan2xud 0 2,404 03-02-2013, 03:26 PM
Last Post: fan2xud

Forum Jump:


Users browsing this thread: 1 Guest(s)