My stupid f*cking 406!!!!!!!!!!

[Dum-Dum]

okay i had a 307 with all the same faults and im sure they are the same. whoever has mapped out the dpf has done it wrong basically, i dont know the ins and outs on the 2.2 but on mine it needed to be deactivated on peugeot planet as well or it would still try and communicate. I had limp mode non stop and its a bugger.

your abs sensor probably just needs to be set up correctly, it needs to be an exact distance from the hub - you could look it up online because i cant remember what it is...1.6mm or something?

and once they are sorted my limp mode and esp/asr was gone and it went well

hope it helps

Do you know any more about deactivating it in PP as me and Niall had a look and couldnt see how.

I dont think my mapper (TB205GTi) will of done anything wrong as hes done a few of these.

The ABS sensors (its the rear ones) will only bolt in one way and theres no adjustment in them.

Have you driven the car after resetting the abs? It needs to be driven so the wheels all start moving and the abs ecu can measure this. The light should go out then..

I have mate, done at least 100 miles over 3 journeys since poodle reset it at the dyno and the fault is still there. When the fault is deleted it just comes straight back without letting the car even get to moving so im kinda guessing a wiring fault.