306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Engine Questions

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Engine Questions
darrenjlobb Offline
Team Chronic Boost!

Registered users - Donated
Posts: 4,604
Threads: 90
Joined: Dec 2011
Reputation: 54
Location: Cornwall
Car Model/Spec: 1996 306 DT M-TDI/16
Facebook Google+ Instagram YouTube
Thanks: 0
Given 20 thank(s) in 18 post(s)
#2
09-01-2013, 08:44 AM
1 - There thrust bearings, take up side to side slop on the crank, there a wearing part / should be replaced ideally...They take side load from the clutch release bearing etc...

2 - I cant see any cracks on that head other than a few around the pre cups which is perfectly normal for a used head tbh..

3 - The rods will come out the top, might just be a bit tight getting rings past the "lip"
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
[Image: sigi-2.png]
Website Find
Reply
Thanks given by:


Messages In This Thread
Engine Questions - by c.gerrard - 08-01-2013, 09:54 PM
RE: Engine Questions - by darrenjlobb - 09-01-2013, 08:44 AM
RE: Engine Questions - by Jonny81191 - 09-01-2013, 10:31 PM
RE: Engine Questions - by Ruan - 09-01-2013, 10:33 PM
RE: Engine Questions - by Piggy - 09-01-2013, 10:45 PM
RE: Engine Questions - by darrenjlobb - 09-01-2013, 10:49 PM
RE: Engine Questions - by londondan86 - 09-01-2013, 10:57 PM
RE: Engine Questions - by c.gerrard - 09-01-2013, 11:03 PM
RE: Engine Questions - by Jonny81191 - 09-01-2013, 11:11 PM
RE: Engine Questions - by samass - 09-01-2013, 11:11 PM
RE: Engine Questions - by Ruan - 09-01-2013, 11:19 PM
Engine Questions - by Jake - 09-01-2013, 11:28 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Few engine related questions Danaidh 15 4,917 22-11-2015, 08:27 AM
Last Post: bashbarnard
  engine rebuild questions blinkyeatu 1 1,742 03-03-2015, 01:21 AM
Last Post: Dave
  306 1.9 TD DTurbo XUD9 engine replace questions ECU shazilla 33 17,958 09-09-2014, 08:35 PM
Last Post: shazilla

Forum Jump:


Users browsing this thread: 1 Guest(s)