10-11-2012, 06:08 AM
Highly unlikely that they will share the same subframe bolt holes so may be a job for mr welder.
Have you thought about the interior from a Roland Garros or possibly looking on eBay France as I'm sure Peugeot did a high spec interior for some of their limited edition models that were sold to the rest of Europe.
One in particular that springs to mind was the 'Break' ltd edition. Seat covers should be a straight swap if a bit of a nuisance but do-able nonetheless, the biggest issue you may have is the size of the hole in the passenger door card for the window switch as the French one will be drivers side which I think is slightly wider so an adaptor plate may be necessary trimmed in carbon film and it should look fine or try and mount the passenger switch in an old broken drivers switch that all the gubbins has been drilled out of and single switch can be hot melt glue gunned in place
Have you thought about the interior from a Roland Garros or possibly looking on eBay France as I'm sure Peugeot did a high spec interior for some of their limited edition models that were sold to the rest of Europe.
One in particular that springs to mind was the 'Break' ltd edition. Seat covers should be a straight swap if a bit of a nuisance but do-able nonetheless, the biggest issue you may have is the size of the hole in the passenger door card for the window switch as the French one will be drivers side which I think is slightly wider so an adaptor plate may be necessary trimmed in carbon film and it should look fine or try and mount the passenger switch in an old broken drivers switch that all the gubbins has been drilled out of and single switch can be hot melt glue gunned in place