Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Snapped an injector
#11
(08-11-2012, 08:39 AM)kernow_joe Wrote: Scrap yard, pocket job done.
(07-11-2012, 09:33 PM)4WayDiablo Wrote: Don't put Lucas injectors on a Bosch pump as they have lower break points and will inject too early iirc
Will run fine though, Bosch injectors are 175 Lucas are 135 but is no problem, Bosch will run better yes, I ran mine on Lucas injectors for ages.
Only saying as if you can only find a set of Lucas will be fine for abit

Are you sure they are 175?
My boach say 218 in big writing,

And either 175 or 173bar in small :/ ..i cant tell exactly Confused

Guy at gsf said "the 2nd injector has a sensor"

Is this true?
Reply
Thanks given by:


Messages In This Thread
Snapped an injector - by RePT - 07-11-2012, 08:50 PM
RE: Snapped an injector - by Matt - 07-11-2012, 09:03 PM
RE: Snapped an injector - by 306Dan - 07-11-2012, 09:06 PM
Re: Snapped an injector - by kernow_joe - 07-11-2012, 09:15 PM
RE: Snapped an injector - by 4WayDiablo - 07-11-2012, 09:33 PM
Snapped an injector - by RePT - 07-11-2012, 10:34 PM
Re: RE: Snapped an injector - by kernow_joe - 08-11-2012, 08:39 AM
RE: Snapped an injector - by Tom - 08-11-2012, 04:34 PM
RE: Snapped an injector - by kernow_joe - 08-11-2012, 07:09 PM
RE: Snapped an injector - by Toms306 - 08-11-2012, 07:15 PM
Snapped an injector - by RePT - 09-11-2012, 02:01 PM
RE: Snapped an injector - by Ricky - 09-11-2012, 03:14 PM
RE: Snapped an injector - by Tom - 09-11-2012, 05:47 PM
Snapped an injector - by RePT - 09-11-2012, 05:56 PM
RE: Snapped an injector - by Tom - 09-11-2012, 06:45 PM
RE: Snapped an injector - by kernow_joe - 09-11-2012, 08:51 PM
Snapped an injector - by RePT - 10-11-2012, 12:38 PM
Re: Snapped an injector - by Dan! - 10-11-2012, 01:07 PM
RE: Snapped an injector - by Daniel306 - 10-11-2012, 02:34 PM
Snapped an injector - by RePT - 10-11-2012, 03:18 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Snapped my banjo Ben Jay 16 5,463 06-05-2013, 09:39 AM
Last Post: Ben Jay

Forum Jump:


Users browsing this thread: 1 Guest(s)