09-01-2012, 04:17 PM
mark_airey Wrote:I'm vouching for nothing, mine was welded
Just get some steel plate, when you change your inlet manifold unbolt the egr valve and cut out a plate roughly the same size as the valve and drill 2 holes in it in the same place as the EGR and bolt into place
Thinking about it my old manifold might be lying around in my workshop, I will have a look later, you can always have the plate off that if its there!
Legend!!!! :dance:
![[Image: signature.png]](http://s22.postimg.org/cgh3ss11t/signature.png)