09-01-2012, 04:12 PM
I'm vouching for nothing, mine was welded 
Just get some steel plate, when you change your inlet manifold unbolt the egr valve and cut out a plate roughly the same size as the valve and drill 2 holes in it in the same place as the EGR and bolt into place
Thinking about it my old manifold might be lying around in my workshop, I will have a look later, you can always have the plate off that if its there!
Just get some steel plate, when you change your inlet manifold unbolt the egr valve and cut out a plate roughly the same size as the valve and drill 2 holes in it in the same place as the EGR and bolt into place
Thinking about it my old manifold might be lying around in my workshop, I will have a look later, you can always have the plate off that if its there!