29-08-2012, 08:46 PM
(28-08-2012, 07:55 AM)strictly_derv Wrote: Good work. Mine only gets full boost at 3,400rpm. Best get the gov lever shimmed some more to make the most of the turbo.
I don't know what sort of power your expecting but the standard 9mm pump can cope very well, mine made 168bhp on the dyno, with clutch slip, boost leaks and no fans to cool the I.C plus the pumps far from maxxed out.
Not at all sure what to expect really, at the moment it isn't going particularly much better than the high boosted k14 I've got on the other zx, but haven't got it set up properly yet, boost starts dropping at about 4k just when the turbo should be getting going (assume fuel / gov issue) and I haven't modded the dynamic advance yet either to go with the high rpms.
What psi are you running?
Still haven't tracked down the boost leak or why it isn't boosting past 20psi - fmic is all up tight, will have to check the fanimolds are done up tight too but the engine was too hot to reach down the back.
![[Image: avatar_zpstlcgvhg8.jpg]](http://img.photobucket.com/albums/v363/toastmonster/avatar_zpstlcgvhg8.jpg){kind=avatar}