Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Do I uprate master cylinder??
#11
Thanks for the replies. It seems that the pedel will go right down yet the brakes will fade as this happens. I have blead them a few times now and it doesn't seem to make any difference.

It is running good quality discs and in previous experience discs will warp rather than cause fade so have ruled that out. The pads are EBC red stuff that I bedded in properly.

I am running comp fluid. I run the same fluid in my group A 106 cup car which runs 4 pot AP's so I am fairly confident that I am not boiling the fluid. I haven't braided the lines yet so that could be a possibility I suppose but looking at the standard ones I don't think they have got too hot.

So on your advice if I change the MC any ideas what I should upgrade to and is it just a case of swapping or do I need to mod anything else??

Thanks again for the advise.
Reply
Thanks given by:


Messages In This Thread
Do I uprate master cylinder?? - by Farmer306 - 21-08-2012, 11:17 PM
RE: Do I uprate master cylinder?? - by CJ_Derv - 22-08-2012, 07:32 AM
RE: Do I uprate master cylinder?? - by C.A.R. - 22-08-2012, 07:40 AM
RE: Do I uprate master cylinder?? - by CJ_Derv - 22-08-2012, 08:04 AM
RE: Do I uprate master cylinder?? - by Ed Doe - 22-08-2012, 08:26 AM
RE: Do I uprate master cylinder?? - by C.A.R. - 22-08-2012, 08:41 AM
RE: Do I uprate master cylinder?? - by CJ_Derv - 22-08-2012, 11:56 AM
RE: Do I uprate master cylinder?? - by Farmer306 - 22-08-2012, 12:37 PM
RE: Do I uprate master cylinder?? - by CJ_Derv - 22-08-2012, 02:39 PM
RE: Do I uprate master cylinder?? - by Ed Doe - 22-08-2012, 02:50 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  HDi 23.8mm Master Cylinder - Where from? Alan_M 3 1,937 07-09-2016, 02:33 PM
Last Post: Alan_M
  23mm Master Cylinder with 266mm Brakes MY95 18 6,489 16-04-2015, 01:42 PM
Last Post: MY95
  Hdi master cylinder tysonbully2k12 0 1,213 24-02-2015, 04:43 PM
Last Post: tysonbully2k12

Forum Jump:


Users browsing this thread: 1 Guest(s)