10-08-2012, 03:38 PM
(10-08-2012, 03:34 PM)CJ_Derv Wrote: im comfused now haha (doesnt take much) do you know the thread on the block? so youve got a banjo end and a female end and a compression fitting into the block which the female end screws onto? dont understand which fitting youve used off old block
sorry for me being so thick today lol
i wanted them to make a hose using the male fitting off original hose going to an elbow with the same thread as banjo bolt into the turbo
No that was my fault I didn't word that the best lol..
On the oil line
Banjo one end.. Compression fitting the other end. Cut up my old oil line and took the bit that threads into the block and attached it to the compression fitting on the oil line.
That make sense? It's hard to explain lol.
On the 306 waiting list.