(08-08-2012, 08:29 AM)Dave Wrote: Fitting is M10x1.5 and if its mounted down back, make it about 1.5 feet long. The other end is a funny fitting so just use the end of a stock pipe with union on it.
Cheers Dave i just need to get the size of the (funny fitting) stock bit to get a fresh pipe made up and can order
as difficult not having car to pop to the place on my dinner as mrs back in work and using her car and peddle power would take too long to get where the hydraulic place is haha
Just found a place in Rochdale that will make ti for about £20 which sounds fair enough he just told me to take the turbo and the old hose and then can make it up for me
)He did say if i could find the thread size and pitch into the block he could have it ready for me
CJ
![[Image: J5hxCcC.jpg]](https://i.imgur.com/J5hxCcC.jpg)