13-07-2012, 07:02 PM
(13-07-2012, 03:58 PM)londondan86 Wrote: Yes mate all bled properly, water only coming out of all bleed points. The head was skimmed and pressure tested by the same company who have been doing it for 20 years, came recommended by a mechanic friend.
I know mate it has me stumped as well!! I can only assume the head/gasket/block is still screwed. Could the heat exchanger have any impact on this?
As far as i no the heater matrix can cause hot spots which can lead to the gasket/head failing yeah Ruan posted a thread about it, think its Do Not Bypass matrix iirc pal,
Let me know how you get on wil ask about see if any of my mechanic mates have had similar prob n try help you out
![[Image: J5hxCcC.jpg]](https://i.imgur.com/J5hxCcC.jpg)