|
Fitting mbc to T2
|
10-07-2012, 08:52 AM
Lol mark; I beg to differ but can see the logic, the time it is taking for 26psi to get through a pipe which is probably 2mm in diameter, I would suggest the potential 'lag' on the actuator spring is fairly minimal. You're talking micro seconds...
Diablo Hdi Dturbo and 205 1.9 project - it lives!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fitting mbc to T2 - by Bananalad - 09-07-2012, 12:04 PM
RE: Fitting mbc to T2 - by Tom - 09-07-2012, 12:10 PM
RE: Fitting mbc to T2 - by ginge191 - 09-07-2012, 12:15 PM
RE: Fitting mbc to T2 - by Bananalad - 09-07-2012, 12:52 PM
RE: Fitting mbc to T2 - by Bananalad - 09-07-2012, 10:04 PM
Fitting mbc to T2 - by Jake - 09-07-2012, 10:08 PM
RE: Fitting mbc to T2 - by Bananalad - 09-07-2012, 10:17 PM
Fitting mbc to T2 - by Jtrigga - 10-07-2012, 12:33 AM
RE: Fitting mbc to T2 - by ginge191 - 10-07-2012, 08:24 AM
RE: Fitting mbc to T2 - by declantg - 10-07-2012, 01:00 AM
Fitting mbc to T2 - by Jake - 10-07-2012, 08:05 AM
RE: Fitting mbc to T2 - by mark_airey - 10-07-2012, 08:27 AM
RE: Fitting mbc to T2 - by ginge191 - 10-07-2012, 08:52 AM
RE: Fitting mbc to T2 - by mark_airey - 10-07-2012, 09:16 AM
RE: Fitting mbc to T2 - by Bananalad - 10-07-2012, 10:36 AM
RE: Fitting mbc to T2 - by ginge191 - 10-07-2012, 10:44 AM
RE: Fitting mbc to T2 - by Dave - 10-07-2012, 11:37 AM
|
