Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rattle under acceleration upto 3k
#31
You can just get a set from a scrappies and try again, they're not coded and they're pretty easy to change... You can just give it a go, there's some scrappies near me with a load of HDis in, I can get you a set if you want, the scrappies are properly cheap, so shouldn't be that expensive...
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in. Wink
Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
#32
Wicked I'll trawl a few see if I can get any in Plymouth !!! Of not m8 ill message you
#33
How sure are you that it's only one that's rattling..? Only ask because i thought the same when i first got mine, and although replacing the one did make a slight difference it wasn't enough to satisfy me.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



#34
I'm trawling scrappies and eBay for all 4 to see if it makes a difference as me being me its just irritating and I dont want the noise :-( may cost me abit but gsf said 110 each if I bring my old units in to for swap which I don't think is too bad for brand new items !!! :-)
#35
For new bosch injectors...? Think you'll be looking at a bit more than that, last time i checked it was well into four figures. Could be refurbed items they're selling i guess...?
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



#36
They were new boxed 110 each and an 85 pound surcharge but I get that back if I bring my old units it for exchange
#37
They won't be brand new ones at that price mate, as Poodle said, they'll definitely be refurbed ones.


Possibly Related Threads…
Thread Author Replies Views Last Post
  Jingle Jangle rattle noise? tigerstyle 9 5,764 06-06-2016, 09:07 AM
Last Post: Toms306
  Rattle on lift off? JTaylor2005 9 5,001 01-06-2016, 02:46 PM
Last Post: JTaylor2005
  The real cause of injector rattle? JTaylor2005 136 83,245 27-05-2016, 07:37 PM
Last Post: Paul_13

Forum Jump:


Users browsing this thread: 16 Guest(s)