Injector Copper Washers

[Mike]

Hi all.. Is there any tips or tricks on getting the coppers washers out?
I cannot for the life of me get it out.. Cant even get it to spin. And I'm out of ideas ):
Any help would be really appreciated.
Thanks
Mike

[Dave]

Get a sharp screwdiver, and hammer into one side of it. When it becomes thin you can bend it into the centre. They are absolute bastards, this comes from years of reusing them and they just get more squashed in the head haha.

[Mike]

Haha... So just smash a screwdriver into the like 'corner' an the praise it inwards.. That how your meanin pal?

---

That what mine looks like at the minute..

---

Made like half the washer thin.. Still wont bend inwards.. Gettin to be a joke this.. Lol

---

Finally got it.. Thanks Dave!! Will rep when I'm on comp (;

[ADV_93]

Get a flat blade screwdriver, and place it vertically against the washer, and hit it downwards. It will buckle the washer then you can pry it out

[shazilla]

Haha... So just smash a screwdriver into the like 'corner' an the praise it inwards.. That how your meanin pal?

---

That what mine looks like at the minute..

---

Made like half the washer thin.. Still wont bend inwards.. Gettin to be a joke this.. Lol

---

Finally got it.. Thanks Dave!! Will rep when I'm on comp (;

Any idea what size they are???

[Danny Wideboy]

Get them from Peugeot, they aren't expensive.

[shazilla]

Thanks for help! Got a set, they are 72p each! Thanks once again!

[Dave]

f*ck me 72p is a f*cking rip off for a piece of copper.