Login

Daniel306 · 22-03-2013, 01:42 PM

Anyone know if the inner drive shalft, the one with the bearing on it., from a Gti6 engine will fit a Xud9?

**Ruan** · 22-03-2013, 03:06 PM

Definitely will, they're essentially the same item. I have GTi6 shafts on mine...

CJ_Derv · 22-03-2013, 04:09 PM

I have odd ones for some reason ling ones a thin shaft and short one is thick one

Jake · 22-03-2013, 04:51 PM

(22-03-2013, 04:09 PM)CJ_Derv Wrote: I have odd ones for some reason ling ones a thin shaft and short one is thick one

Think the phase 1/2 have different thickness. My ph 1 had thicker ones on.

**Dicky** · 22-03-2013, 05:02 PM

Yeah i put '6 shafts on mine

Jonny81191 · 22-03-2013, 06:57 PM

Will ones off a 1.6 fit?

**Dicky** · 22-03-2013, 09:02 PM

(22-03-2013, 06:57 PM)Jonny81191 Wrote: Will ones off a 1.6 fit?

Doubt it

Jonny81191 · 22-03-2013, 10:25 PM

Yeah, Just wondered really as there's a clean 1.6 at the scrappers and my mate needs a new driver's side driveshaft.

Marcus1991 · 23-03-2013, 09:28 AM

Might sound daft, but what's the benefit of GTi6 ones over DTub ones, are they lighter?

**Ruan** · 23-03-2013, 09:37 AM

No benefit, they're essentially the same item...

1.6 ones wont fit 100%

Dan! · 23-03-2013, 09:52 AM

Make sure you change both shafts to gti ones, otherwise you'll just drive round in circles with all the extra power on one side.

Daniel306 · (This post was last modified: 23-03-2013, 11:33 AM by Daniel306.)

A gti one is the only one i had, it turns out that a complete drive shaft is only £57 new

Now i dont have that bearing making any noise