PH2 rad->PH1 rad

[Ricky]

Can I change my radiator for a phase one type by just changing the bottom hose? Or will it not fit in the phase 2 slam panel etc?

Want to get this header tank out of the way, it's ruining my plans!

[kentiiboii]

As far I can I tell the pipes run different.

[Ollie]

Pipes are different. Need to swap the rad.

[Ben]

I am wanting to do this. I brought the radiator and a new bottom pipe but then realised I needed another so I had to put the phase 2 one back on.

The phase one only has one pipe that goes around to the water distributor on the back of the block. I have a silicon end cap to block that. So you'll need one of them or the phase one distributor.

The other thing you'l need is the phase 1 pipe which has the bleed point in it, because the point it attaches to the radiator is lower down so the pipes longer.

[Ricky]

Hmm, sounds like too much effort really, if it was straight swap with maybe just 1 pipe different then it would be worth it.

[Ben]

It's only the one pipe you need to get, and the cap. How much do you want the extra room?

[Ricky]

Not that much, would have just been nice to use it for air filter routing. I am going to use a different route for the filter now anyway.

[ash23]

ricky if you want to do it i am breaking a white ph one dt would have everything you need nc a nissens ally rad

[Ben]

If Ricky doesn't want any of it then ill be interested in a couple of little bits. I'm in no rush though so if Ricky wants them no worries.

[Ricky]

Will drop you a PM ash