Posts: 1,070
Threads: 115
Joined: Oct 2012
08-12-2012, 11:55 AM
(This post was last modified: 08-12-2012, 08:05 PM by 306Puggy.)
Right I've got my dashboard off to do the heater matrix but there is one thing that is stopping me which is the main wiring connector which goes to the dashboard. I cannot for the life of me figure how it comes off. I've taken the allen bolt out and have ended up breaking the plastic over the top but I can't get it off. Haynes just says to disconnect it but doesn't say how. Here's a picture of what I'm talking about:
![[Image: P1010022.jpg]](http://i145.photobucket.com/albums/r233/Flynn_bucket/P1010022.jpg)
I've had a look through the gti guides and they don't mention it being a problem.
Posts: 4,883
Threads: 198
Joined: Jan 2012
Reputation:
135
Location: Not near you
IIRC the allen bolt holds the cover on, but there's another bolt holding the two halves together
Posts: 1,070
Threads: 115
Joined: Oct 2012
Heh, I didn't find out how to remove it but as it happens I didn't have to to access the heating unit.
Posts: 4,608
Threads: 90
Joined: Dec 2011
Reputation:
54
Location: Cornwall
Car Model/Spec: 1996 306 DT M-TDI/16
You dont need to remove that to do the matrix...
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
Posts: 1,070
Threads: 115
Joined: Oct 2012
Yeah I realise that now, I was reading the section of the Haynes entitled "Full fascia removal" which I got muddled up with the heater matrix section.
Posts: 205
Threads: 55
Joined: Nov 2012
Reputation:
0
Location: B north Shropshire
Car Model/Spec: D turbo 1.9
Removing the whole dash in my car but can't get this same connector off does anyone know where the other bolt is that's holds the two halfs together thanks
Posts: 205
Threads: 55
Joined: Nov 2012
Reputation:
0
Location: B north Shropshire
Car Model/Spec: D turbo 1.9
Yeap got it thanks was full of shit so couldn't see it