Posts: 6,258
Threads: 371
Joined: Feb 2014
Reputation:
29
Location: suffolk
Car Model/Spec: ford fiesta
Thanks: 4
Given 82 thank(s) in 82 post(s)
So im putting Lus motor on the ramp soon to do the clutch and turbo. I have a good clutch from a hdi along with all bits. Inc cable. Is the flywheel sensor the same pickup? Or will we loose the rev counter. If so can I combat this somehow??
On a break from 306oc for personal reasons. If anyone needs or wants me most of you have my number and or facebook messenger
Thanks for the good times guys n gals. I might be back. Who knows.
Posts: 1,417
Threads: 34
Joined: Dec 2011
Reputation:
8
Thanks: 0
Given 8 thank(s) in 8 post(s)
Im pretty sure rev counter pickup is different
Posts: 6,258
Threads: 371
Joined: Feb 2014
Reputation:
29
Location: suffolk
Car Model/Spec: ford fiesta
Thanks: 4
Given 82 thank(s) in 82 post(s)
Shit. Any chance of using the xud flywheel then??
On a break from 306oc for personal reasons. If anyone needs or wants me most of you have my number and or facebook messenger
Thanks for the good times guys n gals. I might be back. Who knows.
Posts: 278
Threads: 36
Joined: Nov 2014
Reputation:
4
Location: Falkirk scotland
Car Model/Spec: Berlingo xud / 306 gti6
Thanks: 5
Given 6 thank(s) in 6 post(s)
From my experience hdi sensor on top gearbox like most petrol crank sensors and xud on back block. I have a 180 flywheel with push clutch on ma van. but had to grind off tabs on fly till only 2 left so rev counter would work lol
Posts: 6,258
Threads: 371
Joined: Feb 2014
Reputation:
29
Location: suffolk
Car Model/Spec: ford fiesta
Thanks: 4
Given 82 thank(s) in 82 post(s)
Well ill have to get them side by side and compare.
On a break from 306oc for personal reasons. If anyone needs or wants me most of you have my number and or facebook messenger
Thanks for the good times guys n gals. I might be back. Who knows.
Posts: 38
Threads: 2
Joined: Jan 2015
Location: Rotherham
Thanks: 0
Given 1 thank(s) in 1 post(s)
Country:
HDi flywheel is something like 38-2 toothed setup, XUD is just a simple 4 tooth affair
If using an angle grinder to remove the teeth - be sure that you don't get the flywheel hot, just "tickle" the metal slowly, to reduce heat buildup.
