13-08-2013, 09:04 PM
hiya, does anyone know the max torque or bhp figures a valeo 180mm clutch can hold.
thanks in advance
thanks in advance
|
180mm clutch
|
14-08-2013, 06:00 AM
iirc they start to give when they reach about 220bhp and / or 200lbft, it'll all be relative though, they may 'last' past those figures, but not for long, your best bet if you fancy running a little more power is to fit one of the 200mm clutches from a saxo/106, a couple of the people on the AXOC run standard 200mm on their turbo's, albeit the peeps who run 300+bhp use paddle / ceramic clutches
hope this helps,
Project: Formula Peugeot
14-08-2013, 04:14 PM
Approximately 200-220lb/ft static, but wear at that will be very high, and you'll probably find the clutch overheats and slips on full bore gearchanges and launches. 160-170lbft is more reasonable if you want it to last.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround. 
14-08-2013, 04:51 PM
mine slips at 190lb/ft under full throttle acceleration when it's hot. holds ok otherwise
Member of the 99% warning or you're nothing club |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)