Posts: 107
	Threads: 16
	Joined: Jul 2014
	
Reputation: 
0
Thanks: 7
	Given 1 thank(s) in 1 post(s)
	 
 
	
	
		Another one for the zx and maybe 306 lot
I'm replacing the front left bearing (comes with nut) and my rear brake cables are due a change, 
Does the Zx use reusable hub nuts or are they the type you replace
	
	
	
	
		
	
 
 
	
	
	
		
	Posts: 16
	Threads: 3
	Joined: May 2015
	
Reputation: 
0
Location: Oxon
Car Model/Spec: ZX XUD9 (sorry...)
Thanks: 0
	Given 0 thank(s) in 0 post(s)
Country: 
	 
 
	
	
		When I did the reasr bearings on my old 1.4 ZX with drums the nut was reuseable afterwards, so was the cap after a bit of tapping back in to shape.
No idea if it should be reusable ot not but I still see it locally and it's not been off again (it took a few chisel taps as I got the cap off and I lined the marks back up, they havent moved)
	
	
	
	
		
	
 
 
	
	
	
		
	Posts: 6,367
	Threads: 87
	Joined: Dec 2011
	
Reputation: 
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
	Given 74 thank(s) in 70 post(s)
	 
 
	
	
		The back ones are one use but...... If you swap them to the other side of the car it will give you a fresh piece of nut to stake into place, the fronts are reusable 
	 
	
	
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
	
		
	
 
 
	
	
	
		
	Posts: 6,367
	Threads: 87
	Joined: Dec 2011
	
Reputation: 
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
	Given 74 thank(s) in 70 post(s)
	 
 
	
	
		That's the one fella yes, 
	 
	
	
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
	
		
	
 
 
	
	
	
		
	Posts: 6,367
	Threads: 87
	Joined: Dec 2011
	
Reputation: 
48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Thanks: 2
	Given 74 thank(s) in 70 post(s)
	 
 
	
	
		Haha yes it's pikey, hub nuts are only a few quid each but it's good to know if u cant get hold of any and you need to work on the drums 
	 
	
	
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs