Fitting window to regulator

[doogle-d turbo]

I smashed the passenger window on the xud and I'm fitting the new one.

But how does the bottom of the window fit into the regulator clip?

Cheers for any help

[doogle-d turbo]

Ok got the square clip off but how the hell do you get the rubber washer to sit into the hole in the window?!

Bloody French...

[Ben Jay]

got a picture? i need a bit of a refresh as i did mine about a year ago. from what i remember i used some wd40 and it made slipping it in easier....Giggedy

[doogle-d turbo]

Best I can do there. It's like a pulley shape. Aaahh bit of lube?! I'll give it a go. I'll try spinning the washer as I press it in too.

Cheers mate

[doogle-d turbo]

Turns out the window didn't need to sit inside the groove, the clip just went back on, the washer acts as a bush

[Razorback_Rob]

Just wondered if when doing this if you had a rubber strip along the guide on the side closest to the front of the car? Mine got ruined the other day when having to fit a new lifter bearing in the hole in the window. If it's actually required as mines working without and don't want a nasty surprise. Just thought I'd ask as you've had a look in yours lately

[doogle-d turbo]

My doors are a bit of a state to be honest. There doesn't seem to be one. Do you mean like a weather strip along the white window guide runner? All my weather proofing was removed so I've had a few issues with rain water in the cabin but the window works fine just attached to the 2 clips and in its runner. Both are a tad wobbly if opened at speed though .

[Razorback_Rob]

I think that's the strip I mean too. I got all bunched up and pulled down with the window when I installed the bung not had any leak issues yet as far as I know [FACE WITH TEARS OF JOY] all other weather strips are there so fingers crossed