fmic adapters

[the milkman]

So we all know what these look like the little block ontop of manifold ect. Appears no ones made decent tidy ones of these for a while just wondering if theres any interest I may try knock some up at work? Just give me an idea if no one needs them I wont bother

[4WayDiablo]

*cough* parts section *cough*

---

I *may* be interested. Would have to be cheap. My one flows crap

[the milkman]

Yea was unsure where to post really phil as it was just gauging interest not actually selling any yet and probs be 20+ postage if I make them

[Frosty]

Jimbo and Mikey b were making some

[the milkman]

Not done any for afew month though have they?

[Frosty]

No think the interest went a bit. To be fair most people fit xantia inlets now

[the milkman]

Yea good point but I suppose there getting harder to get hold of now and for some people its a quick easy simple job

[Jenkosowls]

Was going to see if there was any interest in making some nice aluminum ones but after cost and time to make and people's tight arses It isn't worth it! Ideally you need to knock one out in less than an hour to make it worth the £20/30 people seem to want to pay

[the milkman]

Well new jobs welding anyway so was debating on just using all our scrap material to make afew in my lunch breaks ect

[THE_Liam]

Moved to parts

[bigcheez2k3]

Liam is a mod? I really should pay more attention...