27-04-2013, 07:48 PM
I have nowhere to keep my car whilst I break it for parts, so I was wondering if there would be any interest in the shell plus a few bits? would rather it go to a good home because it's too good to be scrapped. Either that or you break it and scrap it.
POXY black shell, with PH3 bumpers + side skirts, Ph3 boot lid.
All the rust was cut out of the rear quarter and new metal welded in, professional job.
Underneath is pretty tidy, think the front chassis legs may need a bit of attention soon.
I will include:
'6 front dampers with spax 40mm lowering springs
Lowered rear beam with hybrid ARB
Bare engine block, DHX. (No pump/turbo/downpipe)
CG 4 paddle clutch
lower BJ, track rod ends droplinks and top mounts replaced within the last 6 months.
Boost gauge
Basically, I will not be including the seats, steering wheel, pump, turbo+downpipe. And possibly a few other little bits.
Not sure what it would be worth, £200? Would obviously need to be trailered.
POXY black shell, with PH3 bumpers + side skirts, Ph3 boot lid.
All the rust was cut out of the rear quarter and new metal welded in, professional job.
Underneath is pretty tidy, think the front chassis legs may need a bit of attention soon.
I will include:
'6 front dampers with spax 40mm lowering springs
Lowered rear beam with hybrid ARB
Bare engine block, DHX. (No pump/turbo/downpipe)
CG 4 paddle clutch
lower BJ, track rod ends droplinks and top mounts replaced within the last 6 months.
Boost gauge
Basically, I will not be including the seats, steering wheel, pump, turbo+downpipe. And possibly a few other little bits.
Not sure what it would be worth, £200? Would obviously need to be trailered.