![]() |
OW! Me knob!!! - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12) +--- Thread: OW! Me knob!!! (/showthread.php?tid=32830) |
OW! Me knob!!! - cheapo - 20-12-2015 It urts me 'and! ![]() And here's why! ![]() This is after I pulled it off. ![]() Ok, it's nice to have a shiny one, but not at the risk of life and limb! So, can I pull my know off completely and replace it, or shall I just stick my Swiss Army knife in there and prize the end off? PS: did this happen because it mentions "Active Member" under my avatar? RE: OW! Me knob!!! - bashbarnard - 20-12-2015 Active member means you've posted a bit I think. And it does just pull off with a bit of grunt. I got a almost new one out a low milager and tiger sealed it on. RE: OW! Me knob!!! - Toms306 - 20-12-2015 I had a nice knob on mine from a newer Pug, bigger and weightier for better grip and a nicer feel. ![]() RE: OW! Me knob!!! - cheapo - 20-12-2015 (20-12-2015, 04:45 PM)bashbarnard Wrote: Active member means you've posted a bit I think. And it does just pull off with a bit of grunt. I got a almost new one out a low milager and tiger sealed it on. I'll have a grunt at it tomorrow then. ![]() (20-12-2015, 04:47 PM)Toms306 Wrote: I had a nice knob on mine from a newer Pug, bigger and weightier for better grip and a nicer feel. I like it already! I might try coating the knob with a layer of epoxy resin and will prolly stick it back on with it as well. Alternatively, some local shop will no doubt have something that will fit the shaft. RE: OW! Me knob!!! - Redordead89 - 20-12-2015 You can just pop the cap off with your Swiss but it's even worse with no cap in it at all! RE: OW! Me knob!!! - cully - 21-12-2015 damaged palms from playing with your Knob is just the worst injury! ![]() |