306 lowering - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Suspension, Transmission, Handling & Braking (https://www.306oc.co.uk/forum/forumdisplay.php?fid=19) +--- Thread: 306 lowering (/showthread.php?tid=23630) |
306 lowering - pbell283 - 28-04-2014 Whats the quickest way to lower a 306 anyone any instructions i hear notch way is but how do u do that ? RE: 306 lowering - THE_Liam - 28-04-2014 Moved to correct section. Have a search mate, this topic has been covered loads of times, or search "darrenjlobb" on Youtube. 306 lowering - pbell283 - 28-04-2014 Darrenjlobb looks big enough job ? What if i take plate out with one bar and jack each hub up then put back in ? RE: 306 lowering - puglove - 28-04-2014 NO, the way Darren shows you on youtube is the only way to do it, The notch method is just removing 1 end of the torsion bar opposed to both ends , but both methods follow the same steps shown in darrens video 306 lowering - pbell283 - 28-04-2014 Ahh ok thanks i was told if i want it 3 nicks just to cut the torsion bars and keep roll bar in RE: 306 lowering - puglove - 28-04-2014 Here look at this http://www.theywhoshallnotbenamed/index.php?pageid=lowering RE: 306 lowering - ConorTRG - 28-04-2014 (28-04-2014, 04:49 PM)pbell283 Wrote: Ahh ok thanks i was told if i want it 3 nicks just to cut the torsion bars and keep roll bar in Whoever said that to you, give them a slap RE: 306 lowering - puglove - 28-04-2014 (28-04-2014, 04:49 PM)pbell283 Wrote: Ahh ok thanks i was told if i want it 3 nicks just to cut the torsion bars and keep roll bar in I think they were pulling your leg, If you cut a torsion bar , you will loose all suspension effect and you rear beam will fall apart as the torsion bars hold the trailing arms on 306 lowering - pbell283 - 28-04-2014 Pug love cheers for the tutorial |