+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Suspension, Transmission, Handling & Braking (https://www.306oc.co.uk/forum/forumdisplay.php?fid=19)
+--- Thread: GTI6 beam fitted, front end now has more roll (/showthread.php?tid=33855)
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
Yes was fully refurbished, bought it off a guy on the GTI forum, was fitted to car and was far too low, then the ride height was changed and set to standard the proper way, although now sits a bit higher on the left (although was done to 330mm apparently), will have another check on flat ground, but sure its a bit out. Is a GTI beam with solid mounts, hence much stiffer at rear than front of the car at the moment.
RE: GTI6 beam fitted, front end now has more roll - powerandtorque - 04-05-2016
When it was raised back up to standard height, was it done with a dummy shock? If not, it's quite easy to get it slightly out side to side if doing it by eye or using a tape measure.
It's been a while since I've done a 306 beam, but 330mm sounds about right for standard height with 20mm torsion bars (which is what a GTi-6 beam has)
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
Wasn't done with dummy shock, just a tape measure, so guess there was probably a bit of error there, really unsure on what to do about stiffer front end now, don't want to have any more understeer from fitting the GTI ARB but don't really want to go any lower, hmmm.
RE: GTI6 beam fitted, front end now has more roll - welshpug - 04-05-2016
from memory the DTurbo HDI has the same springs as a rallye.
330 is what I set all the standard 20mm bar beams for a 306 to.
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
That's interesting welshpug, I used to have a rallye, and it definitely sat lower, will dig out the photo now.
RE: GTI6 beam fitted, front end now has more roll - welshpug - 04-05-2016
bet it was on 50's :p
did the hdi also have its ac removed?
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
Rallye was on 50s on the front and 55 on the back in that photo when I got it
HDI was on 50s all round. HDI didn't have AC removed then, has now though, why do you ask?
RE: GTI6 beam fitted, front end now has more roll - welshpug - 04-05-2016
ah, 55's on the back as well as 50's on the front will bring the nose down even further!
RE: GTI6 beam fitted, front end now has more roll - Toms306 - 04-05-2016
50 profiles? Putting the right size on would give you a bit more clearance for a start lol.
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
Yeah always ran 50s Tom, never driven a 306 on 55s aha
RE: GTI6 beam fitted, front end now has more roll - Toms306 - 04-05-2016
Lol, 55s make a huge difference, more comfortable, fill out the arches better, raise the nose end a bit etc...
Just a shame they cost so much more!
RE: GTI6 beam fitted, front end now has more roll - MY95 - 04-05-2016
That's the issue Tom, plus they don't do Michelin PS3s in 55s either :/
RE: GTI6 beam fitted, front end now has more roll - Toms306 - 04-05-2016
Other brands are available though...
That said I would like to try PS3s tbf.
RE: GTI6 beam fitted, front end now has more roll - MY95 - 07-05-2016
Yeah PS3's are just quite something! so what about mk1 xsara vts 1.8 struts/springs, should be stiffer and a similar height to 306 HDI due to similar engine weights?
RE: GTI6 beam fitted, front end now has more roll - Toms306 - 08-05-2016
Are there any VTS 1.8s? Pretty sure VTS was only the 2.0, essentially equivalent to GTi6.
The 1.8 is a fair bit lighter than the HDi though tbh, but I guess they may've done a sports one with uprated suspension, not sure.
RE: GTI6 beam fitted, front end now has more roll - MY95 - 08-05-2016
The MK1 VTS had the 1.8 112 Tom
So just wondering if the suspension on that will be stiffer, similar ride height and better (as it is a VTS model, and has better steering rack/axle already)
RE: GTI6 beam fitted, front end now has more roll - Toms306 - 08-05-2016
Crikey, that must've been disappointing for anyone buying one.
It's probably got the same springs as a 306 1.8 XS in that case, they sit about the same as the DTurbo HDi and GTi6 but have the lightest engine.
I don't know if the shocks will be any shorter though, as they are on the 2.0 VTS.
RE: GTI6 beam fitted, front end now has more roll - welshpug - 08-05-2016
not in the UK, all 2.0 iron block
RE: GTI6 beam fitted, front end now has more roll - MY95 - 08-05-2016
Here you go Tom
http://www.carfolio.com/specifications/models/car/?car=86779