306oc - Peugeot 306 Owners Club & Forum

never mind, just drilled a hole in the case and tapped it out

was going to say you can get a fitting used when plumbing into a test bench thats what ive got from local derv specialist cost £2 and guage screw straight in

Lol, the wonders of knowledge eh?

I've tapped a 1/8 bsp and going to run hose to gauge in dash, prefer to do it the awkward non oem way, with added swarf bonus

Your pump still on the car?!

This is what I did with the pipe/gauge, although I had the pump off/half strimmed to remove the swarf that falls out into the pump!

(28-09-2012, 04:03 PM)Dave Wrote: [ -> ]Your pump still on the car?!

Good God no, its in a million little pieces on the bench (aka the kitchen table).

Spare pump I'm modding / building up at a snails pace, but prob all good to go back together now and see if it works!

I'm just paranoid swarf has found its way into some little orifice